It is a matter of pride to be the owner of a classic vintage car. It is a joyful and proud moment to be envied by people around you when you are seen enjoying the beautiful summer day in your classic car. People think of it as a matter of prestige to be one among a group that owns these vintage treasures.However, it is only when the summer goes by and is replaced by the winter the reality of protecting your classic car hits you. This is exactly when vintage car owners start considering and thinking about ways of saving their beauties from being effected by the bad weather.Your classic vintage cars can easily be hampered by a lot of vintage issues and so you need to be prepared to handle them effectively. A few ways in which you can handle these winter problems are listed below:Being preparedIt is every vintage car owner’s nightmare to find the vehicle being affected by corrosion. However individuals are not able to clearly identify issues that can happen on the interior. They only see the exterior of the vehicle and recognize scratches, chips and corrosion. It is no doubt mandatory to correct these issues; however it is also true that most of the problems affect the interior of the vintage cars. The most common issue is the formation of rust caused when air combines with water and steel. It should be noted that the water in the air is also sufficient enough to cause corrosion.Handling areas difficult to accessThe only solution to prevent areas difficult to access from corrosion is by proofing them from rust. The most appropriate way to do this is by applying wax based coating to the interior panels of your classic car. Some areas are harder to access and these require holes to be drilled specifically to reach them. The exterior of the cars can use a bit of the same coating as well. A very common rust causing agent is mud because it comes with a lot of moisture.Preventing rust from formingIt is necessary to consider a rust treatment that will effectively prevent rust from being formed on your car. All the dirt and mud from your car needs to be room most of so that corrosion can be spotted easily. When the signs of corrosion are spotted early on, it gets very easy to prevent rust from forming.A good method of preventing rust is by using a rust inhibitor on the stone chips and damaged areas. Once coated with the inhibitor, these areas can be retouched with paint.